Manual Start; Alarm Visualisation; Measurement Stop; Auto Control Or Top Zone - JRI Mini SPY Green Manuel D'utilisation

f)

Manual start

Press shortly on the pushbutton
g)

Alarm visualisation

The Mini SPY RF GREEN is equipped with different alarm indicators, when a threshold limit is
overpassed.
h) Measurement stop
Depending on the configuration, the Mini SPY RF GREEN can stop recording or not. The different
options are:
Rolling memory: once the memory is full, the new values replace the old ones.
Full memory: the recorder stops when its memory is full.
With the software: you can put the Mini SPY RF GREEN in standby mode with Sirius when you do
not use your recorder.
With the pushbutton: this option is valid only if the Mini SPY RF GREEN is configured in transport
mode with a start by pushbutton.
i)

Auto control or top zone

The type of action depends on the Mini SPY RF GREEN configuration.
TOP ZONE = Transport mode
AUTO CONTROL = Storage mode. This function enables you to customise an action of
measurement check-up. You just have to press shortly on the pushbutton.
The action is recorded and will appear on the curve when you process the data with your software
Sirius.
©JRI Maxant
Alarm LED (red):
Flashes every 15''.
T° OK (voyant vert) s'allume
pendant 10''.
Témoin d'alarme (rouge)
s'allume pendant 10''.
Working LED (green):
2'' => starting measurements
then flashes every 2''
To stop your Mini SPY RF BLACK, press between 5 and 10"
on the button:
- The 2 LEDs are on and then flash alternatively.
15