Connection Of Wires; Indoor Unit; Outdoor Unit - GIA Pure Light UV HTWS026PLUV Manuel D'installation

Connection of Wires

1.

Indoor unit

Open upward the inlet grid to the greatest extends.
•
Remove the electric cover from the unit.
•
Loose the screw at connection lid. (Fig.12)
•
Dismantle the wire pressure plate.
•
Connect the power connecting wires and signal control wire separately to the co-
•
rresponding terminals. (In Fig.14,
please choose the same wiring diagram just with the wiring diagram of unit .)
•
Loose off the screw on the earth plate; press earth wire tightly.
•
Press tightly the connecting wires of the unit with lead wire pressure plate.
•
Close the connection lid screw it tightly and close the inlet grid.
•
2.

Outdoor unit

Unscrew and dismantle the electronic device lid(Fig.13).
•
Dismantle the pressure plate of wire fastener.
•
Connect the connecting wires of the unit separately to the corresponding terminals.
•
(Fig.14)
Press tightly the connecting wires of the unit with top pressure plate.
•
Remount the electronic device lid to the original position.
•
If user wants to prolong or replace the power wire, please do it according to the table(-
•
Table3).
Electric cover
Fig.12
Screw
Fig.13
30