Indoor Unit Installation - GIA Pure Light UV HTWS026PLUV Manuel D'installation

Indoor Unit Installation

The tube may be connected in several directions as below shown Figures.
1. Connecting right back tube (similar to right lower tube)
(Optional, Refer to Fig.7)
Pull out the tubing from bottom of the chassis; and
•
connect the drainpipe. Strap the joint of tubing re-
liably.
Lead the connecting wire to the indoor unit (Do not
•
connect to the power).
Strap together the tubes, discharge pipe and con-
•
necting wire with
adhesive tape. The discharge pipe is put at the be-
•
low.
Remove the board which is on the chassis.
•
Check if the connections are reliable.
•
Mount the indoor unit on the two hooks at the upper
part of installation board.
2. Connecting left back tube (similar to left lower tube). (Optional, Refer to Fig9)
Move the discharge tube to the left side, and discharge cap to the right side.
•
Fix the tubes in the slot of the indoor unit with the fix clamp.
•
The following mounting steps are the same as those in "1. Connecting right back
•
tube."
Rightward
Downward
Drain hose
Fixed clamp
Rightback
Fig.7
Fixed clamp
Units connecting wires
Installation
Leftward
Leftback
F ig.9
28
Pipeline
Drain pipe
Fig.6
Wall
board
Fig.8
Drain hose