Publicité
Les langues disponibles
Les langues disponibles
HOW TO USE
Before use
Clean the refrigerator.
Clean your refrigerator thoroughly and wipe off all dust that accumulated
during shipping.
Connect the power supply.
Check if the power supply is connected before use.
Read the "Turning On The Power" section.
Wait for the refrigerator to cool.
Allow your refrigerator to run for at least two to three hours before putting food
in it. Check the flow of cold air in the freezer compartment to ensure proper
cooling.
The refrigerator makes a loud noise after initial operation.
This is normal. The volume will decrease as the temperature lowers.
Open refrigerator doors to ventilat the interior.
The inside of the refrigerator may smell like plastic at first. Remove any adhesive
Pull-out Tray
tape from inside the refrigerator and open the refrigerator doors for ventilation.
IN CASE OF REFRIGERANT LEAK
• Do not touch the refrigerator or the outlet and ventilate the room immediately.
• The explosion by spark may cause fire or burn.
• Because this refrigerator uses natural gas (isobutene, R600a) even a small amount (80~90 g) is
combustible.
• When the gas is leaked by the severe damage during delivering, installing or using the refrigerator, any
spark may cause fire or burn.
CAUTION
Do not scratch the refrigerator with a sharp object or use a detergent that
contains alcohol, a flammable liquid or an abrasive when removing any
tape or adhesive from the refrigerator.
Do not peel off the model or serial number label or the technical
information on the rear surface of the refrigerator.
NOTE
Remove adhesive residue by wiping it off with your thumb or dish detergent.
CAUTION
Putting food in the refrigerator before it has cooled could cause the food to
spoil, or a bad odor could remain inside the refrigerator.
HOW TO USE
11
Publicité
