S&P TD-350/125 SILENT Manuel D'instructions page 10

ENGLISH
This instruction manual contains important infor-
mation and must be read carefully by competent
persons prior to any handling, transport, inspec-
tion or installation of this product. Every care has
been taken in the preparation of the instructions
and information; however, it is the responsibili-
ty of the installer to ensure the system complies
with relevant national and international regula-
tions, especially safety. The manufacturer, Soler
& Palau Sistemas de Ventilación S.L.U. accepts no
responsibility for breakages, accidents or any in-
convenience caused by failure to comply with the
instructions contained in this manual.
The fans referred to in this manual have been
manufactured in accordance with rigorous quality
control and International standard ISO 9001. Once
the product has been installed, this manual to be
retained by the end user.
TRANSPORT AND MANIPULATION
The packaging used for this fan has been designed
to support normal transporting conditions. The fan
must always be transported in its original packag-
ing as not doing so could deform or damage the
product.The fan must always be transported in its
original packaging. Do not accept delivery if the fan
is not in its original packaging or shows clear signs
of having been damaged.
The product should be stored in a dry place in its
original packaging, protected from dust and dirt
until it is installed in its fi nal location.
Do not place heavy weights on the packed product
and avoid impact damage.
Any lifting equipment must be safe and of suitable
capacity for weight and size. Special attention may be
required to ensure fan assembly does not distort or
tilt as weight distribution may vary. Never lift a prod-
uct by pulling it by the wires or terminal casing. Like-
wise, no pressure should be applied on the propeller,
turbine or safety grid while manipulating the product.
IMPORTANT INFORMATION
FOR THE SAFETY OF
INSTALLERS AND USERS
Installation must be carried out
by qualifi ed persons acting in
8
accordance with all safety pre-
cautions applicable and as re-
quired by law, regulations and
standards in the country appli-
cable.
All fans are designed and man-
ufactured in accordance with
EC Directive. Safety guard ac-
cessories are available from
S&P if required due to specifi c
installation. Working ambient
temperature for fan equipment
should not be exceeded typi-
cally this will be within -20°C to
+40°C, unless stated otherwise.
This fan must not be used in
explosive or corrosive atmos-
pheres.
If the fan is used in atmos-
pheres with more than 95% rel-
ative humidity, consult the S&P
Technical Service fi rst.
If the fan is to extract air from
premises where a boiler or
other combustion appliance is
installed, make sure that the
room has suffi cient air intakes
to assure adequate combustion.
This appliance can be used by
children aged from 8 years and
above and persons with reduced
physical, sensory or mental ca-
pabilities or lack of experience
and knowledge if they have
been given supervision or in-