Publicité
Les langues disponibles
Les langues disponibles
Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.
-
Decide the location of the venting pipe from the
hood to the outside. (Figure 1)
-
A straight, short vent run will allow the hood to
perform more efficiently.
-
Try to avoid as many transitions, elbows, and long
run
as
possible.
performance of the hood.
-
Temporarily wire the hood to test for proper
operation before installing. If the hood does not
operate, check the circuit breaker or house
fuse.
If
the
disconnect
power
continuity of all wire connections.
-
Peel protective film off the hood (if any).
-
Use duct tape to seal joints between pipe sections.
-
For installing under the cabinet with recessed
bottom, attach 4-inch wide wood filler strips (not
included) on each side. (Figure 2)
-
Using reference on Page 20-21 to measure and
create access opening for electrical wires and
exhaust under the cabinet.
Vent option installation
CAUTION:
USE HAND TOOLS ONLY. DO NOT
OVER TIGHTEN SCREWS. IT MAY CAUSE DAMAGE TO
THE HOOD.
1. Choose the require vent option. Some installation
screws are already pre-attached to hood.
2. For 6" Round vent installation only:
-
The 6" exhaust is already attached. (Figure 3)
Align and secure the 6" Round Plastic Collar {F}
to two screws on hood.
3. For Top 3-1/4" x 10" vent installation only:
-
Remove attached 6" exhaust and discard.
(Figure 3) Keep 13 screws to install 3-14" x 10"
exhaust & vent cover.
-
Align and secure Top Vent Cover {E} and 3-1/4"
x 10" Exhaust {D} using 14 screws (13 screws
taken from 6" exhaust. (Figure 4)
4. For Rear 3-1/4" x 10" vent installation only:
-
Remove attached 6" exhaust and discard.
(Figure 3) Keep 13 screws to install vent covers.
-
Remove duct knockout from back of the hood
and discard. (Figure 5) Unscrew 3-1/4" x 10"
Vent Cover from rear exhaust (located inside
hood); keep screws to install 3-1/4" x 10"
exhaust.
UNDER CABINET INSTALLATION
This
may
reduce
hood
is
still
not
supply
and
Figure 1
the
Figure 2
working,
check
the
Figure 3
Figure 4
8
Publicité
