Kuppersbusch FK3800.0i Instructions D'utilisation page 25

What to do if...
Problem
The appliance does not op‐
erate.
A or symbol is shown
instead of numbers on the
Temperature Display.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
Possible cause
The appliance is switched
off.
The mains plug is not con‐
nected to the mains sock‐
et correctly.
There is no voltage in the
mains socket.
The door is left open.
Temperature sensor prob‐
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The "Shopping function" is
switched on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Close the door. Refer to "Door
open alarm"
Contact the nearest Author‐
ised Service Centre (the cool‐
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation".
Wait few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor‐
ing.
Refer to "Closing the door".
Refer to "Shopping function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
25