Publicité
Les langues disponibles
Les langues disponibles
Warning
Open the cover, turn the side handle and remove the cutting disc, if present, only when the machine is switched
off. Then, through the upper (round) opening and by pressing once the green start button followed by the red
stop button, check that the direction of rotation of the central spindle is anti-clockwise. If the direction of rotation
is not correct, reverse two of the three power supply wires (inside the plug or socket).
3.3. SAFETY MEASURES AND TRAINING THE FINAL USER
The skilled personnel in charge of the installation and electric connections of the equipment is responsible of the
training of the final user, which must also be informed on the safety measures to comply with. This instruction
manual comes with each equipment.
4. USE OF THE EQUIPMENT
The controls and pilot light are sent on the right side
of the base when the machine is located in front of the
operator.
1.green button for starting the machine
2.red button for stopping the machine
4.2. SETTING THE DISCS ON THE MACHINE
Turn the knob as shown in figure no.1 and open the cover. First set the plastic ejection disc (2), then the disc
selected for cutting. Close the cover and reverse the rotation of the knob. Operate the start button to automatically
engage the discs in the correct position.
10
Publicité
