Publicité
Les langues disponibles
Les langues disponibles
CAUTION
!
If the appliance was shipped, handled, or stored in other
than an upright position for any period of time, allow the ap-
pliance to sit upright for a period of at least 24 hours before
plugging in. This will assure oil returns to the compressor.
Plugging the appliance in immediately may cause damage
to internal parts.
WARNING
!
WARNING - Help Prevent Tragedies
Child entrapment and suffocation are not problems of
the past. Junked or abandoned refrigerators are still
dangerous - even if they sit out for "just a few hours".
If you are getting rid of your old refrigerator, please
follow the instructions below to help prevent acci-
dents.
Before you throw away your old refrigerator or
freezer:
•
Take off the doors or remove the drawers.
•
Leave the shelves in place so children may not
easily climb inside.
Select Location
The proper location will ensure peak performance of your
appliance. We recommend a location where the ice ma-
chine will be out of direct sunlight and away from heat
sources. To ensure your product performs to specifications,
the recommended installation location temperature range is
from 55 to 90°F (13 to 32°C) for built in ice machines. Your
ice production will be negatively impacted outside these
recommended temperatures.
Cabinet Clearance
Ventilation is required from the bottom front of the appli-
ance. Keep this area open and clear of any obstructions.
Adjacent cabinets and counter top can be installed around
the appliance as long as the front grille remains unobstruct-
ed.
INSTALLING YOUR APPLIANCE
Front Grille
Do not obstruct the front grille. The openings within the
front grille allow air to flow through the condenser heat ex-
changer. Restrictions to this air flow will result in increased
energy usage, loss of cooling capacity and low ice produc-
tion. For this reason it is important this area not be obstruct-
ed and the grille openings kept clean. AGA MARVEL does
not recommend the use of a custom made grille as air flow
may be restricted. (See Figure 2).
Leveling Legs
To assure proper performance from your ice machine it is
important to level the unit in the installation. Adjustable legs
at the front and rear corners of the appliance should be set
so the unit is firmly positioned on the floor and level from
side to side and front to back. The overall height of your
Marvel appliance may be adjusted between the minimum,
34" (86.4 cm), by turning the leveling leg in and the maxi-
mum, 35" (88.9 cm) by turning the leveling leg out.
To adjust the leveling legs, place the appliance on a solid
surface and protect the floor beneath the legs to avoid
scratching the floor. With the assistance of another person,
lean the appliance back to access the front leveling legs.
Raise or lower the legs to the required dimension by turning
the legs. Repeat this process for the rear by tilting the appli-
ance forward using caution. On a level surface check the
appliance for levelness and adjust accordingly.
The front grille screws may be loosened to raise or lower
the grille to the desired height. When adjustment is com-
plete tighten the two front grille screws. (See Figure 5).
Figure 3
4
CAUTION
!
Front Leveling
Legs
Figure 2
Do not remove
ground prong
Front Grille,
keep this area
open.
Rear
Leveling
Legs
Figure 4
Publicité
