Publicité
Les langues disponibles
Les langues disponibles
Door ajar alarm:
If the door is open, or not closed properly for
5 minutes the "DOOR" indicator will illuminate
and flash and an audible tone will sound. This
alarm condition can be reset by closing the door or
momentarily pressing the "ON/OFF" icon, (i.e.-if you
are cleaning the storage compartment, etc.). The
alarm will recur in 5 minutes if the alarm condition persists.
If the door is intentionally left open for long periods, the
alarm can be disabled by turning the unit off.
Delay start/Vacation mode:
Your ice machine is equipped with a delay start function.
This feature can be used to temporarily shut the appliance
off for 1, 4, 6, or 8 hours or days. Upon completion of the
selected delay period, the appliance will resume operation.
This is ideal for temporarily stopping ice machine noises or
to save water and electricity if you are away from home but
want fresh ice upon your return.
To enter the delay start mode, press the "CLOCK"
icon while the appliance is in "ICE" mode. This will
delay the next harvest by the time displayed. Each
additional press of the "CLOCK" icon will add time,
from 1, 4, 6, or 8 hours, to 1, 4, 6, or 8
days. The next press after 8 days will
leave delay set mode. After the desired
time has been selected, press the "ON/OFF" icon
for 2 seconds to accept, your unit will shut off and a
clock icon and your selected time will be displayed.
When the selected time has elapsed, normal ice pro-
duction will resume.
To cancel the delayed start, press and
hold the "ON/OFF" icon until the appli-
ance enters OFF, then press and hold
the "ON/OFF" icon again until the appli-
ance enters "ICE" mode.
Error codes:
The ice machine is monitored continuously. Any OPEN or
SHORTED circuit condition with a temperature sensor or
miscommunications between the control and user interface
will initiate an ERROR CODE as listed below:
Error
"OFF" will flash continuously in 1
Bin Sensor error
second intervals in the display. No
audible alarm will sound.
"ICE" will flash continuously in
System Sensor error
the display. No audible alarm will
Continual flashing of all indicators
Communication error
USING YOUR ELECTRONIC CONTROL
DOOR
1
4
6
OFF
Displayed Code
Failed temperature sensor. Machine operation will imme-
Failed condenser temperature sensor. Machine opera-
tion will continue but ice production cycle will not adapt to
sound.
varying ambient conditions, so ice quality may vary.
Loss of communication between the main board and the
on the display.
Options menu:
Normal and ECO mode:
Your ice machine comes with an optional "ECO" mode.
This new feature allows you to tailor ice production to a
conservative rate, saving approximately 25% energy and
water from routine operation. While in this mode
ice production will slow and the appliance will use
less water and electricity. It is recommended that
"ECO" mode only be initiated after there is a full bin
of ice. To enter "ECO" mode do the following:
•
Press the "MENU" icon twice and the green
"ECO" will flash.
•
Press and hold the "ON/OFF" icon until the green
"ECO" stops flashing and remains illuminated.
•
To return to the standard operating rate press
the "MENU" icon twice, the ECO will turn off
and the "ICE" will be flashing. Press and hold
the "ON/OFF" icon until the "ICE" stops flashing and
remains illuminated.
hours
days
8
ICE
Error Codes
Error Description
diately enter an OFF state.
user interface.
15
ECO
ICE
Action to Take
Call service to have the
temperature sensor replaced.
Call service to have the
temperature sensor replaced.
Call service to have a
diagnostic check.
Publicité
