Publicité
Les langues disponibles
Les langues disponibles
hydrogen, hepatic gas, sulphur dioxide, aerosol, propellant, alcohol preparation, paint, thinner, dissolvent, bonding agents,
shampoo, aftershave balm, perfume, car exhaust (cold start) and certain cleaning agents.
MAINTENACE:
To keep your CO detector in proper working order, please follow these easy steps:
•
Once a month, check that the alarm is working properly by pressing the test button.
•
Clean the CO detector with a vacuum cleaner or with a soft cloth or brush once every month to remove excess dust.
•
Check whether the batteries are damaged, exhausted or corroded.
•
Explain to children that they should not play with the CO detector.
•
Ensure children are aware of the dangers of carbon monoxide poisoning.
•
Never use cleaning agents or other solutions to clean the CO detector.
•
Never use air fresheners, hair spray or other aerosols near the CO detector.
•
Don't paint the CO detector. Paint covers the vents preventing the sensor from detecting CO.
•
Never disassemble, repair or modify the product yourself; there's a high risk that it will no longer function correctly or
reliably.
BATTERY REPLACEMENT
Remove the battery cover on the back of the unit by sliding the cover off the product, you will now have access to the
batteries.
Remove the batteries from the unit and replace them with 3x new High Energy Alkaline batteries 1,5V AA - LR6, making
sure that the battery polarity matches the instructions in the battery compartment.
SENSOR REPLACEMENT:
The sensor has a lifetime of 10 years. After 10 years you need to replace the complete product, the sensor itself is not
exchangeable.
If the yellow LED illuminates within these 10 years, even though you've reconnected or replaced the batteries, please refer
to the paragraphs Reason for sensor fault and Sensor fault caused by chemical gases.
If the yellow "FAULT" LED lights up 3x and 3 beeps per minute are heard, the entire product should be replaced. This is the
End of life warning.
SPECIFICATIONS:
Power supply:
Sensitivity and time:
standby consumption:
consumption at alarm:
Sound pressure at alarm:
Environmental conditions
during use:
Type:
ENVIRONMENT:
Do not throw away used batteries, but recycle them using your local chemical depot. Product may not be thrown out as
normal waste, but must be recycled as electrical waste.
DECLARATION OF PERFORMANCE
The declaration of performance is available on the website http://DOC.hesdo.com/COA3920-DOC.pdf
3 x LR6, 1,5V AA high energy Alkaline batteries
30ppm, alarm is not activated within 120 minutes
50ppm, alarm is activated within 60~90 minutes
100ppm, alarm is activated within 10~40 minutes
300ppm, alarm is activated within 3 minutes
<30µA
<65mA
>85dB (3m distance)
-10~+45°C, 0~93% humidity.
Type B (unchecked output)
42
Publicité
