Siemens TE65 F Serie Mode D'emploi page 44

en Menu
■ Use I to choose the desired water
hardness and touch B to confirm
your choice.
F
It is important to set the water hard-
ness correctly, so that the appliance
indicates accurately when the
descaling programme should be run.
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier. If a water softening
system is installed in the house, please
select the Softening system setting.
■ Briefly dip the test strip in the water and
check the result after one minute.
Level Water hardness
German (°dH) French (°fH)
1 1-7
2 8-14
3 15-21
4 22-30
Automatic shut-down
Setting how long the appliance should wait
after the last drink was prepared before it
automatically switches itself off.
You can specify values from 15 minutes to
3 hours. The factory setting is 30 minutes.
■ Use I to choose the desired interval
and touch B to confirm your choice.
Coffee temperature
Specifying the temperature for coffee drinks
and hot water.
You can choose normal, high, or max.
The setting applies to all types of drink
preparation.
■ Use I to choose the desired
temperature level and touch B to
confirm your choice.
Water filter
Specifying whether a water filter should be
activated or whether no filter is used.
You can choose Activate new filter or
No filter.
40
1-13
14-25
26-38
39-54
F
A water filter lessens limescale
deposits and reduces impurities in
water. The appliance also does not
need to be descaled so often.
Water filters are available from retail outlets
or from customer services (see the section
"Accessories").
F
Important: Before you can use a
new water filter it will need to be
rinsed.
■ Use the measuring spoon 8 to press the
water filter firmly into the water tank 5.
■ Fill the water tank with water up to the
"max" mark.
■ Connect the milk tube 4c to the milk
system 4b and the suction pipe 4d.
■ Insert the end of the suction pipe 4d into
the drip plate 17b.
■ Touch A and use I to select
Water filter.
■ Touch B and use I to select
Activate new filter.
■ Empty the drip tray and re-insert.
■ Touch B to confirm.
Water will now flow through the filter to
rinse it.
■ Then empty the drip tray and re-insert.
The appliance is ready for use again.