Siemens TE65 F Serie Mode D'emploi page 37

Initial use
General
Fill the appropriate container using only
pure, cold, uncarbonated water and solely
roasted beans. Do not use coffee beans
that have been glazed, caramelised or
treated with other additives containing
sugar, since they will block the brewing unit.
The water hardness setting on the
appliance can be adjusted. The factory
setting for the water hardness is 4. Use
the enclosed test strip to determine the
hardness of your water supply. If this
shows a value other than 4, you will need
to programme the appliance appropriately
after it has been taken into service (see
section "Menu – Water hardness").
Setting up the appliance
■ Remove any protective plastic film.
■ Place the fully automatic coffee machine
on a level, waterproof surface that is able
to support its weight.
■ The appliance's ventilation slits must not
be covered or obscured.
F
Important: Only use the appliance
in a frost-free room. If it has been
transported or stored at temperatures
below 0°C, wait at least 3 hours
before taking it into operation.
■ Connect the power supply (cable storage
compartment 18) to the socket. You can
adjust the length of the cable by pulling it
further out or pushing it back in. To do this,
place the appliance with its back flush
with the edge of the work surface and
either pull the cable out downwards or
push it in upwards.
■ Flip up the lid of the water tank 6.
■ Remove the water tank 5, rinse it out and
fill it with fresh cold water. Do not fill it
past the "max" mark.
■ Replace the water tank 5, making sure
that it is straight, and push it right down
into place.
■ Reclose the lid of the water tank 6.
■ Fill the bean container 9 with coffee beans.
■ Use the main switch J 1 to switch on the
appliance.
The control panel and the display will
be activated. The display will show the
previously specified language, which will
also be used for all subsequent display
texts. A number of different languages are
available.
■ Touch I repeatedly until the display
indicates the desired language.
Deutsch
English
Français
■ Touch C to confirm your
selection.
The chosen language is now stored.
The brand logo will light up on the display 3.
The appliance will heat up and rinse itself,
a small amount of water will run out of the
drink outlet 4.
The appliance is ready for use when the
symbols and the display on the control
panel are lit.
F
The factory settings of the fully
automatic coffee machine are
programmed for optimal perfor-
mance. The appliances switches off
automatically after a configured time
(see the section "Menu – Automatic
shut-down").
Initial use en
33