Publicité
Les langues disponibles
Les langues disponibles
LIGHTS ON/OFF BUTTON
Press "LIGHTS ON/OFF" to turn on or turn off both the flame and fuel bed at the same time.
FLAME BUTTON
Press "FLAME" button to select the colour of flame (3 colours) or return to the OFF position.
MOOD LIGHT BUTTON
Press "MOOD LIGHT" button to select the colour of mood light (13 colours), colour-cycle mode or
return to the OFF position.
NOTE: The controls on appliance will lose the memory for all function settings when the switch is
set to the Off Position. When the remote runs out of power or when you change the batteries, only
the flame function will lose memory and will not affect the timer settings, however, the clock may
need adjusting.
3.2 Operating by Remote Handset
•
Make sure the batteries are installed properly in the remote control.
•
The effective range of the remote control is up to 4 meters or 13 feet.
NOTE: This is a thermostatic remote control. The remote should be in the same room as fireplace and
placed on a flat surface. It must be placed away from the heater so the hot air will not blow on it and
affect thermostatic reading.
The communication frequency between the fire and remote has already been set up. If you cannot use
the remote with the fire, please follow instructions Step 3.2.34 to initiate this connection in point.
Stand-by for Remote Handset
3.2.1 The screen shown to the right is when the remote handset is in standby condition.
Turn on/off
3.2.2 Press
to turn on the flame effect, turn off flame effect and heater when in normal
mode.
3.2.3 Press
to turn on/off the flame effect under daily and weekly timer mode.
19
Publicité
