Bosch KGN36HI32 Notice D'utilisation page 44

en Home Connect
Deactivating the cameras:
Press alarm off button.
1.
The refrigerator compartment
temperature display shows Cn.
Keep pressing + button refrigerator
2.
compartment until the refrigerator
compartment temperature display
shows CA and the freezer
compartment temperature display
shows On.
Press - button freezer compartment.
3.
The freezer compartment
temperature display shows OF.
The cameras are disabled.
Resetting Home Connect settings
If there is a problem when trying to
establish a connection or if you would
like to register the appliance in a
different home network (WLAN), the
Home Connect settings can be reset:
Press alarm off button.
1.
The refrigerator compartment
temperature display shows Cn.
Keep pressing + button refrigerator
2.
compartment until the refrigerator
compartment temperature display
shows rE and the freezer
compartment temperature display
shows OF.
Press + button freezer compartment.
3.
The freezer compartment
temperature display shows an
animation for 15 seconds.
The freezer compartment
temperature display then shows OF.
Wi-Fi connection display does not
light up.
The Home Connect settings have
been reset.
44
Installing updates for the
Home Connect software
The refrigerator checks at regular
intervals whether updates are available
for the Home Connect software.
If an update is available, the refrigerator
compartment temperature display
shows "UP".
Pressing any button will reset the
display to the set temperature.
Installing the update:
Press the alarm off button.
1.
The refrigerator compartment
temperature display shows Cn.
Press button + refrigerator
2.
compartment until the refrigerator
compartment temperature display
shows UP and the freezer
compartment temperature display
shows OF.
Press button + freezer compartment.
3.
The freezer compartment
temperature display shows an
animation.
The update will be installed.
During the installation, all buttons are
locked.
If the installation was successfully
–
completed, the freezer
compartment temperature display
will show On.
If the installation was not
–
successfully completed, the
freezer compartment temperature
display will show Er.
Start the update again at a later
point in time.
Inform the Customer Service if
the installation has still not been
successfully completed after
several attempts.