Mitsubishi Electric CITY MULTI Smart ME Controller Manuel D'installation page 9

• Cut out the thin-wall part on the cover (indicated with the shaded
area in the right figure) with a knife or a nipper.
Note:
Make sure that the hole edges are smooth and will not damage
the wires.
4 Install the bottom case.
• Remove the sheath as shown in the figure at right, and route the
remote controller cable behind the bottom case.
Install the bottom case.
■ Installation using a switch box
• Secure at least two corners of the switch box with screws.
■ Direct wall installation
• Secure at least two corners of the remote controller with screws.
• Be sure to secure top-left and bottom-right corners of the remote
controller (viewed from the front) to prevent it from lifting.
(Use molly anchor etc.)
■ Installation using a switch box
Double switch box
Roundhead
cross slot
screws
Important
To avoid damage to the controller, do not
overtighten the screws.
5 Install the top case on the bottom case.
Two mounting tabs are at the top of the top
case.
Hook those two tabs onto the bottom case,
and click the top case into place. Check that
the case is securely installed and not lifted.
* The controller is shipped with the front cover mounted to the top case.
Remove the front cover from the top case before installing the top case on the wall.
Refer to "1 Uninstalling the front cover" on page 12.
■ Direct wall installation
Seal the cable
access hole
with putty.
Wood
Refer to 2.
screws
Remote
controller
cable
To avoid damage to the controller, do not
make holes on the controller cover.
– 9 –
Sheath
60 (2-3/8)
6 (1/4)
Unit: mm (in)
Remote
controller
cable
Wall
Should not
be lifted