2
Component names and supplied parts
The following parts are included in the box.
Parts name
Remote controller (front cover) *1
Remote controller (top case) *1
Remote controller (bottom case)
Roundhead cross slot screws M4×30 *2
Wood screw 4.1×16 *2
(for direct wall installation)
Installation Manual (this manual)
Instruction book
*1 The front cover is already installed on the top case at
factory shipment.
*2 ISO metric screw thread
*3 Remote controller cable is not included.
3
Field-supplied parts/Required tools
(1) Field-supplied parts
Parts name
Double switch box
Thin metal conduit
Locknut and bushing
Cable cover
Putty
Molly anchor
Remote controller cable
(0.3 mm² (AWG 22) 2-core
sheathed cable)
(2) Required tools
• Flat-tip screwdriver (Width: 4-5.5 mm (5/32-7/32 in))
• Knife or nipper
• Miscellaneous tools
Qty.
1
1
1
Front cover
4
4
1
1
Qty.
1
As needed
Not required for direct wall installation
As needed
As needed
Required for routing remote controller cable along a wall
As needed
As needed
If the remote controller cable exceeds 10 m (32 ft), use an
electric wire that meets the following specification.
As needed
CVVS: 1.25 mm
CPEVS: ø1.2 mm (standard AWG 16) or equivalent
– 4 –
Top case
Bottom case
Notes
2
(standard AWG 16) or equivalent