Danby DAC8000 Guide D'utilisation Et Soins De Propriètaire page 6

Installation Instructions
WARNING
When handling unit, be careful to
avoid cuts from sharp metal edges
and aluminum fins on front and rear
coils.
HOW TO INSTALL
NOTE: Top Rail and Sliding Panels at each side are offset to provide the
proper pitch to the rear of (5/16"). This is necessary for proper condensed
water utilization and drainage. If you are not using the Side Panels for
any reason, this pitch to the rear must be maintained to allow water build
up in humid conditions to drain outside.
Place unit on floor, a bench or a table. There is a Left and Right Window
1
Filler Panel - be sure to use the proper panel for each side.When installed
the flange for securing the panel in place to the window sill will be facing
into the room.
A. Remove the backing from the top mounting rail seal strip and attach the
seal strip to the bottom of the top mounting rail, along the front edge.
B. Attach the top mounting rail onto the top of the case with 2/5" screws.
5
Top Mounting Rail
FRONT VIEW
Seal strip
2/5" Screws
Top Mounting Rail
Remove
backing
from seal
strip
Top Mounting Rail