Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
DIGITAL CONTROLS
REMOTE CONTROL
COOL MODE
ENERGY SAVER MODE
FAN ONLY MODE
AUTO FAN SPEED
POWER OUTAGE
RECOVERY FEATURE
• To ensure proper operation, aim the remote control at the signal receiver
on the air conditioner.
• The remote control signal has a range of up to 20 feet.
• Make sure nothing is between the air conditioner and the remote control
that could block the signal.
• Make sure batteries are fresh and installed correctly as indicated on the
remote control.
Use the Cool mode at Low, Med, High or Auto Fan Speed for cooling.
Use the Temperature Increase
temperature between 64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room temperature. The
compressor will cycle on and off to keep the room at the set level of com-
fort. Set the thermostat at a lower number and the indoor air will become
cooler. Set the thermostat at a higher number and the indoor air will
become warmer.
NOTE: If the air conditioner is off and is then turned on while set to a Cool
setting or if turned from a fan setting to a Cool setting, it may take approxi-
mately 3 minutes for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling — Select the Cool mode and High or Med fan with
a middle set temperature. For Maximum Cooling — Select the Cool
mode and High fan with a lower set temperature. For Quieter &
Nighttime Cooling — Select the Cool mode and Low fan with a middle
set temperature.
The fan will cycle on and off with the compressor. This results in wider
variations of room temperature and humidity. Normally used when the
room is unoccupied.
NOTE: The fan may continue to run for a short time after the compressor
cycles off.
Use the Fan Only Mode at Low, Med or High fan speed to provide air cir-
culation and filtering without cooling. Since fan only settings do not
provide cooling, a Set temperature cannot be entered. The room
temperature will appear in the display.
NOTE: Auto Fan Speed cannot be used when in the Fan Only Mode.
Set to Auto fan speed for the fan speed to automatically set to the speed
needed to provide optimum comfort settings with the set temperature.
If the room needs more cooling, the fan speed will automatically increase.
If the room needs less cooling, the fan speed will automatically decrease.
NOTE: Auto Fan Speed cannot be used when in the Fan Only Mode.
In the case of a power outage or interruption, the unit will automatically re-
start in the settings last used after the power is restored. If the Delay
1–24hr feature was set, it will countdown according to the memorized
time. You may need to set a new time if desired.
10
/ Decrease
pads to set the desired
Publicité
