Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
Please Note:
To assure proper installation, it is suggested that a qualified person or carpenter install the Koala Kare
Baby Changing Station. Koala Kare Products will not be responsible if the station is not installed properly.
Koala Kare Baby Changing Stations have been tested to hold a substantial static load. The unit must be
attached to a permanent wall that is capable of holding a substantial load. The maximum recommended
total weight for this baby changing station (including baby and parcel bag) is 60 lbs. Excessive weight
may cause a hazardous or unstable condition to exist.
Restraint System: To fasten the waist restraint strap, place strap around child's midsection, and push
spring tabs into buckle until both spring tabs lock in place with an audible "click". Straps can be adjusted
to make strap tighter or looser as required.
Inspection Criteria:
A properly maintained baby changing station:
– Opens and closes smoothly
– Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is attached to unit
at both ends.
– Offers parents liners through a fully stocked liner dispenser. (Dispenser built into unit.)
– Provides a clean, convenient place for customers to attend to their children.
Measuring
Tape
Gloves
Drill
Four 1/4"x 3"
Phillips Panhead
Wood Screws
1
TOOLS NEEDED
Phillips Head
Screwdriver
1/8" Drill Bit
(regular and
masonry)
HARDWARE PROVIDED
Level
7/32" Drill Bit
(regular and
masonry)
Four 1/4"
Flat
Washers
Stud
Finder
Pencil
1/2" Drill Bit
(regular and
masonry)
Publicité
