Language Selection; Cleaning And Maintenance - Fagor PL-2410 E Manuel D'utilisation

disconnect automatically. "
appear on the LCD screen and the light
will go off. To reconnect, simply move the
iron. N.B: the iron will take 60 seconds to
reach its previous temperature.

11. LANGUAGE SELECTION

Hold the "lower temperature" setting down
for 2 seconds (7) (Fig. H). EN will appear
on the LCD screen (4). Press the "lower
temperature" setting (7) again to change the
language. The language will change from EN
(English ) to DE (German), and from DE to
FR (French). To select the desired language,
press the "increase temperature" setting (6)
and the language selected will be set.. N.B.:
The default language is English.

12. CLEANING AND MAINTENANCE

Cleaning the water reservoir
Unplug the iron. To empty the water reservoir,
open the water inlet cover (8) and hold the
iron with the hole facing downwards until all
the water has run out (Fig. I). Shake the iron
gently to remove any drops left inside.
Storage
Leave the iron to cool down before storing
it away. If you do not use the iron on a daily
basis, it is a good idea to empty the water
reservoir after each use to extend the useful
life of the iron. Wind the cord around the
support base (do not wind tightly) and store
the iron away on its base.
Cleaning
Unplug the iron and wait until it has cooled
down before cleaning it. Clean the outside
and the sole with a damp cloth. Do not use
detergent or abrasive products. Do not
immerse the iron in water or run it under
the tap.
Self-clean
This function will remove limescale and
minerals accumulating in the steam chamber.
The sole will need to be self-cleaned once
" will you have used the steam function for 5
hours. When this is needed, the
will appear on the LCD screen (4).
1. Half-fill the water reservoir, as described
in Section 3 "Filling the water reservoir".
2. Place the iron upright and plug it in.
Press the "increase temperature"
regulator (6) to turn on the unit.
3. Set the maximum temperature. See
Section 4 "Setting the temperature".
4. Hold the "increase temperature"
setting (6) down for 2 seconds to
switch the iron off and then unplug it.
5. Place the iron upright in the sink and
hold the self-clean button (10) down.
6. The steam and hot water will remove
the limescale and minerals created in
the steam chamber.
7. Move the iron carefully forward until
the water reservoir is empty and let go
of the self-clean button.
8. Place the iron on its support base and
leave it to cool down completely.
9. Wipe the sole with a damp cloth.
13. INFORMATION FOR THE
CORRECT DISPOSAL OF ELECTRICAL
AND ELECTRONIC APPLIANCES
a dealer providing this service. Disposing of a
household appliance separately avoids possible
negative consequences for the environment
and health deriving from inappropriate disposal
and enables the constituent materials to be
recovered to obtain significant savings in energy
and resources.
To remind you that you must collaborate with a
selective collection scheme, the symbol shown
appears on the product warning you not to
dispose of it in traditional refuse containers.
For further information, contact your local
authority or the shop where you bought the
product.
14
symbol
At the end of its working
life, the product must not be
disposed of as urban waste.
It must be taken to a special
local authority differentiated
waste collection centre or to