Dry Ironing; Steam Ironing; Automatic Shut-Off - Fagor PL-2410 E Manuel D'utilisation

6. DRY IRONING

1. Place the iron on a stable surface and
plug it in. The LCD display (4) will light
up for a second, and a beep will sound
when it switches off.
2. Press the "increase temperature"
regulator to switch on the iron. The
display will then show "ACRYL" and the
iron will start to heat up.
3. Select the right temperature. See
Section 4. "Setting the temperature"
4. When you hear the beep and the "
symbol appears, the iron is hot and
ready to use.
5. If you want to disconnect the iron, hold
the "increase temperature" setting (6)
down for 2 seconds (Fig. D). The screen
will go off with a beep.
6. Unplug the iron and let it cool down
before storing it away.

7. STEAM IRONING

1. Fill the iron as described in section 3 "Filling
the water tank" and plug it in. The LCD
display will light up for a second, and a beep
will sound when it switches off.
2. Press the "increase temperature" regulator
to switch on the iron. The display will show
"ACRYL" and the iron will start to heat up.
3. Select the right temperature. See Section 5
"Setting the temperature".
4. Select the steam option by pressing the steam
button (5). The iron will give a whistle and the
symbol will start flashing.
5. When you want to disconnect the steam, again
press the steam button (5). The
stop flashing.
6. If you wish to disconnect the iron, hold the
"increase temperature" setting (6) down for 2
seconds (Fig. D). The screen will go off with a
beep.
7. Unplug the iron and let it cool down before storing
it away.
8. SPRAY
To use this function there must be water in
the reservoir. If you wish to obtain a spray
of water to dampen dry or difficult-to-iron
fabrics, press the spray button (2). The
spray function is also useful to dampen
creases created by accident while ironing.
The spray of water will come through the
spray nozzle (9) (Fig. E).
N.B.: It may be necessary to press the
spray button several times to activate this
function.
Switch the iron on, as indicated in Section 7
"
"Steam ironing". When the iron has reached
the temperature selected, press the extra
steam button (3) while ironing and the
steam will come through the holes in the
sole (Fig. F) onto the fabric, smoothing out
the most difficult creases. Wait for at least
5 seconds between each use of the extra
steam button so as to allow the iron to heat
up again and thereby obtain the maximum
amount of extra steam.
Upright steam: The extra steam function
also works when the iron is in an upright
position. To use this function, hold the iron
upright around 15-30 cm away from the item,
press the extra steam button (3), and the
steam will come out of the holes in the sole
(Fig. G).
CAUTION: Do not direct the iron towards
people as the temperature of the steam is
very high.
The shut-off function will work automatically
symbol will when the iron is left unattended whilst
connected to the mains.
• Automatic shut-off while the iron is
horizontal position or lying on its side:
If the iron remains immobile for 30 seconds
in an ironing position (horizontal or on its
side), the iron will disconnect automatically.
The "
and the light will go off. To reconnect, simply
move the iron.
• Automatic shut-off in the upright position:
If the iron remains immobile for 8 minutes
on its support base (upright), the iron will
13
9. EXTRA STEAM

10. AUTOMATIC SHUT-OFF

" pause symbol on the LCD screen