Publicité
FILTER REMOVAL
The filter can be removed from its slot by gripping the filter handle and sliding it out from the back of the appliance.
Remove the filter every two weeks and clean it with warm water, below 40°C.
MAINTENANCE INSTRUCTION
1.
Place the unit on a stable flat surface to avoid loud noises and vibrations.
2.
Never insert any slim rod and hard object into the unit body to avoid occurrence of hazard or unit failure.
3.
If the unit will not be used for a long time, please pull out the power cord from the outlet.
4.
For a better dehumidifying effect, the areas in front and rear of the unit should be clear and free from obstacles, which will
block the air flow for the unit.
5.
Clean the filtering net once every two weeks (never use alcohol, gasoline, or hot water with a temperature of 40°C).
SPECIFICATIONS
MODEL
SPECIFICATION
DEHUMIDIFICATION (litre/day, 30°C and RH
80%)
RUNNING CURRENT
POWER
VOLTAGE
REFRIGERANT
DIMENSIONS
TROUBLESHOOTING
Problem
The unit does not work.
The device does not dehumidify.
The air does not flow out.
All manuals and user guides at all-guides.com
filter
handle
filter
DryFix 10EQ
10 l
1,2 A
260 W
220V-240V/50Hz
134a
280 x 500 x 160 mm
Possible cause
Is the unit plugged in?
Does the "tank full" indicator (water tank
is full or misplaced) light up?
Is the ambient temperature higher than
35 ° C or lower than 5 ° C?
Is the air filter dirty?
Is the air inlet or outlet blocked?
Is the air filter dirty?
Solution
Plug in the unit.
Empty the water tank and set it to the
correct position again.
The heat protection has been activated,
the device cannot be operated.
Clean the air filter as described in the
manual.
Check the air inlet and outlet and
remove any obstructions.
Clean the air filter as described in the
manual.
Publicité
