Publicité
OPERATION INSTRUCTIONS
Starting the unit
1. Plug in the dehumidifier.
2. Turn the switch to the "ON" position.
3. Power indicator lights green, the unit automatically determines dehumidification level according to the ambient temperature
and is then placed in the dehumidification mode.
4. To turn off the unit, turn the rotary switch to the "OFF" position, Power indicator is off.
5. Once the water tank is full, the compressor switches off. Water tank indicator lights red.
PRECAUTIONS
1.
The dehumidifier will not start if the humidity setting is higher than the ambient humidity.
Empty the water tank if it's full and the water level indicator light illuminates. Then install the empty water tank back to its
2.
position, so the unit can continue its operation.
3.
When the unit stops, you have to wait for 3 minutes before you can restart the unit to protect the compressor from damage.
4.
The operational temperature range for this unit is 5-35 C°.
5.
If the dehumidifier does not start (the operational light does not illuminate) or the dehumidifier makes intermediate stop on
unknown reasons, please check the plug and power supply for poor connection. If the plug and power supply are in normal
condition, wait for 10 minutes and restart the unit. If the unit still does not start in 10 minutes, please contact your dealer for
repair.
6.
When the dehumidifier is in operation, the running compressor will produce heat and make the room temperature higher.
This is normal condition.
USE OF WATER TANK
When the water full indicator illuminates, the tank is full, and the compressor and the fan will stop operation. Please empty the
water tank:
1.
Turn off and unplug the unit
2.
Remove the water tank and empty it.
3.
Insert gently the water tank back into the unit.
CONTINOUS DRAINAGE
1.
If you want to use this function, please take out the rubber plug from the bottom of the device.
2.
Insert the spring into the 1cm wide side of the drainage tube.
3.
Insert the end of the hose (with the spring) in the drainage opening in and fix the hose with the clip.
4.
Place the other end of the hose in a suitable vessel so that the water can flow into it.
All manuals and user guides at all-guides.com
Push the clip of each side to enlarge the opening and put it onto the hose
Publicité
