Makita ADP03 Mode D'emploi page 6

ENGLISH
1 Battery cartridge
2 Charging lights
3 Refreshing lights
CAUTION:
1. SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for the
refreshing adapter.
2. Before using the refreshing adapter, read all instructions and cautionary markings on (1) refreshing adapter,
(2) battery charger, (3) battery, and (4) product using battery.
3. CAUTION – To reduce risk of injury, charge or refresh only MAKITA rechargeable batteries. Other types of batter-
ies may burst causing personal injury and damage.
4. Non-rechargeable batteries cannot be charged or refreshed with the refreshing adapter.
5. Use a power source with the voltage specified on the nameplate of the charger.
6. Do not use the refreshing adapter in presence of flammable liquids or gases.
7. Do not expose the refreshing adapter to rain or snow.
8. Never carry charger by cord or yank it to disconnect from receptacle.
9. After charging or before attempting any maintenance or cleaning, unplug the charger from the power source. Pull
by plug rather than cord whenever disconnecting charger.
10. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or
stress.
11. Do not operate charger with damaged cord or plug — replace them immediately.
12. Do not operate or disassemble charger if it has received a sharp blow, been dropped, or otherwise damaged in
any way; take it to a qualified serviceman. Incorrect use or reassembly may result in a risk of electric shock or fire.
13. The refreshing adapter is not intended for use by young children or infirm persons without supervision.
14. Young children should be supervised to ensure that they do not play with the refreshing adapter.
15. Do not charge or refresh a battery cartridge when temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F).
16. Do not attempt to use a step-up transformer, an engine generator or DC power receptacle.
17. Do not allow anything to cover or clog the charger vents.
18. Use this adapter with Makita battery charger DC14SA, DC14SC, DC18RA, DC18RC, DC18SC, DC24SA or
DC24SC.
Automatic refreshing charge
1. Insert the adapter into charger until it stops adjusting to the guide of charger. Terminal cover of charger can be
opened with inserting and closed with pulling out the adapter.
2. Plug the battery charger into your power source. Two charging lights will flash in green color repeatedly.
3. Insert the battery cartridge into adapter until it stops adjusting to the guide of adapter.
4. When the battery cartridge is inserted, the adapter selects normal charge or automatic refreshing charge auto-
matically.
5. When the adapter selects normal charge, the charging light colors will change from green to red and normal
charge will begin.
6. When the adapter selects automatic refreshing charge, the charging light colors will change from green to red and
one refreshing light will flash in green color repeatedly and quickly. Then, automatic refreshing charge will begin.
7. With the finish of normal charge and automatic refreshing charge, the charging light colors will change from red to
green.
8. When you press the conditioned refreshing button, the charging light colors will change from green to red and one
refreshing light will flash in green color repeatedly. Then, conditioned refreshing charge will begin.
9. With the finish of conditioned refreshing charge, the charging light colors will change from red to green. Then, the
refreshing lights indicate the battery capacity compared with a new battery.
6
Explanation of general view
4 Terminal cover
5 Automatic refreshing adapter
6 Conditioned refreshing button
7 Battery charger