Gloria FineCut 18V Mode D'emploi page 33


store battery in a dry, elevated, closed,
frost-protected space at a tempera-
ture between 0 °C and + 45 °C. When
storage temperature is +15 °C, self-dis-
charge and chemical ageing is at its
lowest. Avoid direct sunlight.
11 Problems with the device
11.1 Troubleshooting the
Faults usually occur if the device has not been handled, cared for or maintained properly. The
following table contains the most common faults and remedies to eliminate these faults. If
you have any other problems, please contact your nearest service centre authorised by the
manufacturer, or your nearest authorised specialist dealer.
Fault Cause
Battery not inserted properly
Battery capacity too low
Device does not
Faulty battery
start
Battery overheating, battery status
indicator lights up red
Status display batt.;
Temperature protection
4 displays flash
Status display batt.;
Low voltage cutoff
1 display flash
Battery not inserted properly
Battery charging
Battery contacts dirty
display continu-
ously lit, charging
is not possible
Faulty battery
Mains plug for the charger has not
been plugged in (properly)
Battery charging
display does not Mains outlet, power cable or char-
light up ger defective
Cutting unit Cutting unit is blocked by cut
blocked material, twigs or foreign objects
Cutting unit is Cutting unit is not sufficiently
stiff lubricated
Grass is cut is too
Incorrect height adjustment
long / too short

if the battery is not used for more
than 6 months, use the status indica-
tor to check the charging status in
the charger. Recharge the battery to
approx. 40-60% capacity if required.
and the Al 1810 CV battery charger
Remedy
Insert the battery into the holder
until it clicks into place
Charge the battery
Battery defective or at the end of its
life. Replace the battery!
Allow the battery to cool down
Allow the device and the battery to
cool down for around 5 minutes and
do not use them in that time
Charge the battery
Insert the batt. correctly into the charger
Clean the battery contacts, e.g. by
plugging in and unplugging the bat-
tery several times, if necessary
Replace the battery
Insert the mains plug (fully) into the
mains outlet
Check the mains voltage. If necessa-
ry, have the charger checked over by
an authorized repair shop for GLORIA
electrical power tools
Clean the blade on the cutting unit
and move it
Lubricate the cutting unit
Adjust the height of the wheels
33