Gloria FineCut 18V Mode D'emploi page 30

9
Following a successful charging proce-
dure, first disconnect the charger plug
from the power outlet, then remove the
battery from the charger.
8 Use and commisioning
Figures 10 - 15
WARNING
BEFORE COMMISIONING OBSERVE
CHAPTER 2 "FOR YOUR SAFETY".
8.1 Inserting the battery
ATTENTION
10
When inserting the battery, ensure that
the contacts at the device and the bat-
tery itself are dry. Insert the charged
battery into the device as shown into
place.

Make sure that the surface to be cut is
free from debris e.g. stones, screws etc.,
which could be flung up.
8.2 Commisioning
ATTENTION
Improper use of the device poses a
risk of damage to property! You
should therefore observe the follow-
ing safety instructions:

When working on the lawn border,
make sure that you do not damage
the edge of the curb (e.g. when tilting
or tipping the device) or that the edge
of the curb damages or bends the
blade bar.

The knife blades are precisely
adjusted for grass cutting. Cutting
branches and bushes will result in a
loss of pre-tension and thus reduce
the quality of the grass cut.

Check the lawn surface to be trimmed
beforehand to avoid damage to
device/objects or injuries to living
beings. Power lines, stones, pieces of
wood, wires or the like, as well as
other foreign objects must be
removed. Objects that the grass
trimmer pick up can be cut.
NOTE!
11
Remove the blade guard (K).
12
Clean the grass trimmer before or after
each use. Oil the blades with machine
oil or spray lubricating oil before or
after use.

Before using the grass trimmer, first
mow the lawn using the lawnmower /
lawn robot.

Adjust the cutting height (3/4/5 cm) as
described in section 6.2.

Place the
switch the device on.
13
Now move the device once slowly for-
wards and back on the lawn. Do not
apply pressure to the device. Leaving
the grass trimmer at one position for too
long can damage the turf
NOTE!
If too much cut grass settles on the
blade bar, switch off the device, lift it
slightly and shake off the grass.
ATTENTION
Improper use of the device poses a
risk of damage to property! You
should therefore observe the follow-
ing safety instructions:

When cutting around curbs, fences, or
trees, make sure the blade bar does
not come into contact with them.
12
Oil the blades at least once an hour
(machine oil or spray lubricating oil).
8.2.1 Angle adjustment
Your
angle adjustment mechanism (I) which
allows you to trim your lawn even in hard-
to-reach areas. Proceed as follows to
adjust the angle of the tube:
CAUTION
RISK OF INJURY FROM OSCILLATING
METAL BLADES!

Switch off your device when adjust-
ing the angle!
30
on the lawn and
is equipped with an