Adjusting The Controls - Med-Fit 3 Manuel D'instruction

Chapter 11 : ADJUSTING THE CONTROLS
1. Slide Cover
A sliding panel covers the controls for Pulse Width,
Pulse Rate, Mode Selector and Modulation Selector.
Take advice from your clinician regarding the settings
and then leave the cover in place.
2. Power On/Off Switch and Intensity Control
If both controls are in the off position the device is inactive
Turn the controls clockwise to activate the unit. A
black dot appears in the LED to indicate that stimulation
has commenced. The intensity increases as the
control is turned further clockwise.
In order to reduce the intensity or to switch the unit off turn the con-
trol anti-clockwise.
3. Lead Connector
Ensure that the unit is switched off. Connect the electrodes to the
lead by inserting the plugs into the electrode connectors. Plug the
lead into the unit and press the
12
14