Electrodes - Med-Fit 3 Manuel D'instruction

Chapter 10 : APPLICATION OF RE-USABLE SELF
Application
1. Clean and dry the skin at the thoroughly with soap and water prior
to application of electrodes.
2. Insert the lead wire into the pin connector on the pre-wired

electrodes.

3. Remove the electrodes from the protective liner and apply the
Removal
1. Peel the electrodes from the skin; do not pull on the lead wires
because it may damage the electrodes.
2. Place the electrodes on the liner and remove the lead wire by
gently twisting and pulling.
Care and Storage
1. Between uses, store the electrodes on their liner in the re-seal
able bag in a cool dry place.
2. The adhesive properties of the electrodes may be improved by
applying a few drops of cold water and allowing the electrode
surface to dry. Do NOT soak the electrodes.
Important
1. Do not apply to broken skin.
2. The electrodes should be discarded when they no longer adhere.
3. The electrodes are intended for single patient use only.
4. If irritation occurs, discontinue use and consult your clinician.
5. Read the instruction for use of self-adhesive electrodes before
application.
ADHESIVE ELECTRODES
11
11