Preparation For Use - Med-Fit 3 Manuel D'instruction

Chapter 8 : ATTACHMENT OF ELECTRODE
The wires provided with the system insert into the jack sockets lo-
cated on top of the device. Holding the insulated portion of the con-
nector, push the plug into one of the jacks (see drawing); one or two
sets of wires may be used.
After connecting the wires to the stimulator, attach each wire to an
electrode. Take care when you attach and detach the wires. Jerk-
ing the wire instead of holding the insulated connector body may
cause wire breakage.
CAUTION
Do not insert the plug of the patient lead wire into the AC power
supply socket.
Chapter 9 : PREPARATION FOR USE
It is recommended that for persons with sensitive skin, the area is
prepared prior to the application of the self adhesive electrodes by
cleaning using soap and water or alcohol wipes and then drying
thoroughly. It is quite normal to see a reddening of the skin underneath
the electrodes following treatment but this usually disappears in less
than 2 hours.
If the reddening persists we recommend PALS (BLUE) electrodes
LEAD WIRES
10
10