Velleman CAMSETW8 Mode D'emploi page 2

5. Description Receiver (fig. 4)
1. IR signal receiving window
2. antenna
3. channel button
4. LED channel display
5. power jack
6. video output
7. audio output (L)
8. audio output (R)
9. channel number (1-4)
10. lock/unlock key
11. channel +
12. loop key
13. channel –
14. power switch
6. Installation
1. Put the camera in the desired location and then adjust the angle.
2. Connect the adapter to each camera.
3. Connect the receiver to a monitor/TV with the A/V cable (yellow for video, red and white for audio).
4. Connect the adapter (DC 12V 300mA) to the receiver. Slide the power switch to the ON position. The power
indicator lights.
5. Switch on the monitor/TV and select A/V mode.
6. Use the channel button to
now displayed on the monitor/TV.
7. Rotate the lens for optimum focus.
8. Adjust the brightness, contrast and colour of the monitor/TV and the direction of the receiver's antenna.
9. Remove the battery insulator from the remote controller; pull out the battery tray and then load one button cell
(type CR2025) correctly. You can operate the receiver with the remote control.
7. Operation
a) Channel button on receiver
CH1 → CH2 → CH3 → CH4 → Channel loop → CH1
b) IR remote control
Keys
1.
2.
3.
CAMSETW8
set the same channel on the receiver as on the camera. The picture of the cameras is
individual channel selection
channel up or down
scanning for specific channels
Functions
2
Operation & display
1. Press loop key once to start
setting, " " flashes
2. Press keys 1 – 4 to enter two or
more channels to be looped
3. Press loop key again to confirm
and scanning begins
VELLEMAN