Montipower BRISTLE BLASTER Mode D'emploi page 9

®
BRISTLE BLASTER ELECTRIC SINGLE
• ensure good ventilation of the workplace and keep clean using a vacuum cleaner as
sweeping or blowing stirs up dust.
• vacuum or wash protective clothing. Do not blow, beat or brush.
5. Initial Operation
Before plugging in, check that the rated mains voltage and mains frequency, as stated
on the rating label, match with your power supply.
Always install an RCD with a max. trip current of 30 mA upstream.
5.1 Attaching the Vibration Damping handle
Always work with the vibration damping handle (4) attached! Attach the handle on the
top or bottom side of the machine, depending on working position, and secure. See
Figure 5.
Figure 5
5.2 Attaching the Protective Cap
Always work with the Protective Cap (6) attached.
Installing:
Slide the Protective Cap (6) over the cams on the front end as shown below and secure by
tightening the screw on the side.
1
Figure 6
2
EN
3
9