Montipower BRISTLE BLASTER Mode D'emploi page 12

EN Operating instructions
7.3 Working instructions
F
8. Cleaning
To clean the motor, hold the tool firmly
slots regularly and thoroughly, FIGURE 2.
9. Troubleshooting
Mains powered machines:
•
Overload protection: There is a MAJOR reduction in load speed.
high! Allow the machine to run at idle speed until it has cooled down.
• Overload protection: There is a SLIGHT reduction in load speed.
Reduce the load before continuing to work.
• S-automatic safety shutdown: The machine was SWITCHED OFF automatically.
If the slew rate of the current is too high (for example, if the machine suddenly seizes or
kickback occurs), the machine switches off. Release the Dead man's switch to switch off the
machine. Switch it on again and continue to work as normal.
12
Press down lightly on the machine and
move over the surface by making oscillating
movements.
Correct direction of operation.
Less contact pressure = longer service life and
higher performance.
Note that excessive pressure will lead to
F
damaging the Bristle Blaster
break of tooth belt.
and blow compressed air through the rear ventilation
®
BRISTLE BLASTER ELECTRIC SINGLE
®
Belt and even
The motor temperature is too
The tool is overloaded.