Montipower BRISTLE BLASTER Mode D'emploi page 10

EN Operating instructions
6. Fitting the Adaptor System & Bristle Blaster
Disconnect the tool from its power source before changing the belt or Adaptor
System. The machine must be switched off and the spindle at a standstill.
6.1 Positioning the accessory
See Figure 7.
a) Fasten Bristle Blaster
Adaptor System (pay attention to rotation direction) and serrated lock washer and
screw.
Figure 7
b) For Bristle Blaster
c) Before plugging in to operate the tool, you must check that it is possible to actuate
the Dead man's switch correctly and that the switch returns to the "OFF" position when
you release the pressure on the Dead man's switch.
d) To start the tool, release the safety clip by pushing it backwards and push
the Dead man's switch (Figure 8).
Figure 8
10
®
Belt correctly to the tool using the MontiPower
®
stainless steel belts, use only the stainless steel Accelerator Bar.
BRISTLE BLASTER
®
Belt
®
ELECTRIC SINGLE
®