Hitachi NT 65MA2 Manuel D'instructions Et De Sécurité page 23

CHANGING THE EXHAUST DIRECTION
● When changing the exhaust direction, be sure to remove your
finger from the trigger and disconnect the air hose from the nailer.
The direction of the exhaust vent can be changed
by turning the top cover.
USING THE NOSE CAP
● When attaching or detaching the nose cap, be sure to remove
your finger from the trigger and disconnect the air hose from the
nailer.
If you like to protect the surface of workpiece
against scratches or markings made by the push
lever, attach the accessory nose cap to the push
lever.
1 DISCONNECT AIR HOSE FROM NAILER.
2 Put the nose cap to the toe of the push lever.
3 The nose cap is marked to indicate the exit
point of the nail, making alignment easier.
4 When not using the nose cap, secure in the
storage compartment located on the reverse
side of the magazine.
NOTE:
● The nose cap may reduce nailing depth due to
its thickness. Re-adjustment of nailing depth is
required.
WARNING
Exhaust
Vent
WARNING
Nose Cap
Magazine
Top Cover
1
Disconnect
Push
air hose
Lever
2
Nose Cap
English
23