Harvia SENTIOTEC Pro B3 Instructions De Montage Et Mode D'emploi page 66

Instructions for use for the user
9.3. Switching on the sauna control unit
WARNING!
Risk of fire
Flammable objects that are placed on the sauna heater could ignite and
cause fires.
● NEVER place flammable objects on the sauna heater.
● Make sure that NO flammable objects have been placed on the sauna
heater before the sauna control unit is switched on.
● Press the ON/OFF switch
► In the humidity display
rent humidity in the sauna room is displayed. If a humidity temperature
sensor is not installed, the last preset humidity is displayed.
► In the temperature display
current temperature in the sauna room is displayed. In single-sensor
mode, the previously set preset temperature is displayed.
9.4. Starting sauna mode
1. Use the temperature selector
► The temperature selector
in the temperature display
2. Press the temperature selector
► The sauna heater is switched on and begins to heat up.
► Then the current temperature in the sauna room is displayed in the
temperature display
is displayed.
, to switch on the sauna control unit.
6
, "0" appears for a few seconds. Then the cur-
1
, "0" appears for a few seconds. Then the
4
to set the preferred temperature.
3
flashes and the preset temperature is shown
3
.
4
.
3
. In single-sensor mode, the preset temperature
4
p. 28/38