Harvia SENTIOTEC Pro B3 Instructions De Montage Et Mode D'emploi page 64

Installation instructions, only for experts
8.5. Displaying the heater temperature in single-sensor mode
In single-sensor mode, the sauna control unit only displays the set temperature
as standard. The actual temperature is not displayed. Should the sauna control
unit display the temperature above the heater (F1) as an actual temperature in
single-sensor mode, it must be activated with the function selection switch 8.
● The function selection switch 8 is set to the ON position as standard. Therefore
only the set temperature is displayed.
● Should the temperature above the heater be displayed as an actual tempera-
ture, place the function selection switch 8 in the OFF position.
Ensure that the temperature above the heater is always higher than the
temperature in the area of the bench seat. With the heater temperature
as the actual temperature, the temperature displayed by the sauna con-
trol unit is higher than the temperature measured by your sauna room
thermometer.
p. 26/38