Harvia SENTIOTEC Pro B3 Instructions De Montage Et Mode D'emploi page 44

Instructions for installation and use p. 6/38
2. Important information for your safety
The sauna control unit Pro B3 has been produced in accordance
with the applicable safety regulations for technical units. However,
hazards may occur during use. Therefore adhere to the following
safety information and the specific warning notices in the individual
chapters. Also observe the safety information for the devices con-
nected.
2.1. Intended use
The sauna control unit Pro B3 is used exclusively for operating and
controlling the sauna functions in accordance with the technical data.
The sauna control unit Pro B3 may only be used for operating and
controlling a sauna heater which has been certified as satisfying
the combustion test described in paragraph 19.101 of EN 60335-
2-53. If the heater does not meet this requirement, an appropriate
safety precaution must be taken (for example: safety shut-off, see
5.8 on page 19).
The sauna control unit Pro B3 may only be used for operating and
controlling 3 heating circuits with a maximum heating capacity of
3.5 kW per heating circuit. The maximum evaporator capacity totals
3.5 kW.
Any use exceeding this scope is considered improper use. Improper
use can result in damage to the product, in severe injuries or death.