4. TECHNICAL DATA
Model
Engine type
Self Propel
Engine Displacement
Nominal Power
Blade Width
Idle Speed
Fuel Tank Capacity
Oil tank capacity
Grass catch bag capacity
Net Weight
Height adjustment
Guaranteed sound power level at the operator's position
(According to EN ISO 5395-1 Annex F & EN ISO 5395-2,
EN ISO 4871)
Measured sound power level
Guaranteed sound power level (According to 2000/14/EC)
Vibration
(According to EN ISO 5395-1 Annex G & EN ISO 5395-2)
5. ASSEMBLY
5-1 ASSEMBLY THE FOLDING HANDLE
A) Fix the lower handlebars into the unit body with
locking knobs as shown. (Fig. 2, Fig. 3, Fig. 4, Fig. 5)
B) Release the upper handlebars for folding. Connect the
upper handle and the lower handle with the locking
knob. (Fig. 6, Fig. 7)
C) Position all cables over the handle shafts. Clamp them
around the middle of lower handles by the cable
clamps so that the cables are fixed on the outside of
the machine. Otherwise the cables may be pinched by
opening/closing the rear cover or forced by folding the
upper handle. (Fig. 8)
5-2 ASSEMBLY THE GRASS CATCHER
1. To fit: Lift the rear cover and hang the grass catcher on
the shaft of rear of mower. (Fig. 9, Fig. 10)
2. To remove: Grasp and lift the rear cover, remove grass
catcher.
5-3 STARTER HANDLE
Move the starter handle from the engine to the rope guide.
(Fig. 11, Fig. 12)
5-4 HEIGHT OF CUT
Apply outward pressure to disengage lever from rack.
Move lever forward or back to adjust height. (Fig. 13 and
see clause 8-9)
6. ADJUSTMENT FOR AN
APPROPRIATE HANDLE
HEIGHT
1) Back out the locking knob which fixed the lower
handle, refer to Fig. 14.
10
PM-5101 S3C
B&S 675EX series, ReadyStart
190 cm
510 mm
2,800/min
37.7 kg
25 – 70 mm, 5 adjustment
86.6 dB (A)
(K = 3 dB (A))
94.9 dB (A)
K = 1.78 dB (A)
98 dB (A)
4.17 m/s²
K = 1.5 m/s²
2) Refer to Fig. 15, move the lower handle up and down,
adjust it to the proper height.
There is 3 adjusting height to be choose on this type
lawn mower; at 1 height, lower handle to the ground is
highest., 3 height is the lowest.
3) Adjusting to the proper height, then fix the lower
handle by the locking knobs.
WARNING: The left side and right side of lower
handle must adjust to the same height.
7. "3 in 1"
This lawn mower can be retrofitted from its normal
function, based on the application purpose:
From rear-discharge mower to:
1. Mulching mower or
2. Side-discharge mower.
What is mulching?
When mulching, the grass is cut in one working step, then
finely chopped and returned to the grass strip as natural
fertilizer.
Hints for mulch-mowing:
- Regular cut-back by max. 2 cm from 6 cm to 4cm grass
height.
- Use a sharp cutting knife - Do not mow wet grass
- Set max. Motor speed
- Only move at working pace
- Regularly clean mulching wedge, housing inner side
and mowing blade
Yes
3
2.5 kW
1.0L
0.6L
65L