Télécharger Imprimer la page

SOGETRONIC VISION 2 SET Manuel D'utilisation page 26

Masquer les pouces Voir aussi pour VISION 2 SET:

Publicité

Les langues disponibles

Les langues disponibles

Cartridge weight excl. extra weight 2.5g
Note:
· Design and specifications are subject to change without notice.
Turntable Maintenance
1. Do not touch the stylus tip with your fingers. Avoid bumping the stylus on the turntable
mat or a record's edge.
2. Clean the stylus frequently with a soft brush with a back-to-front motion only.
3. Clean the records to get rid of dust or grease with a record cleaning brush and record
cleaning solution.
4. Clean the turntable lid and turntable cabinet with a slightly damped microfiber cloth.
Note: Do not use cleanser other that contains alcohol,benzene or any other harsh
chemicals, with might damage the paint and finish of the turntable.
Troubleshooting
There is no power
· Power adaptor is not connected correctly.
· No power at the power outlet.
Power is on, but the platter does not turn
· This unit is not in turntable mode. Press the MODE button to turntable mode, the
indicator light in red.
· Need to press the PLAY / STOP button once to start playing.
· Turntable's drive belt is not installed or has slipped off.
Turntable is spinning, but there is no sound, or sound not loud enough
· Stylus protector is still on.
· Tone arm is lift up by the lever.
· The Phono/Line switch is set at PHONO position but RCA jacks connected to the stereo
system's line input.
· Forget to connect the speaker to the turntable.
Record sounds too fast or too slow
· Wrong speed selected for the record.
Strong hum on phono input
· The cable is not grounded correctly.
Remark:
To comply with ERP standards, the whole unit will switch to power off mode automatically if no
music has been playing for about 15 minutes.
If your unit switches off
To restart the unit, please press the POWER Button "OFF" then "ON".
regularly, this is no defect.
EN - 25 -

Publicité

loading

Produits Connexes pour SOGETRONIC VISION 2 SET