Publicité
Les langues disponibles
Les langues disponibles
Initial Setup
Essential Setup
1. Place the unit on a flat and level surface. The selected location should be stable and
free from vibration.
2. Install the turntable lid to the hinges.
3. Remove the tie-wrap that is holding the tonearm.
4. Put the drive belt around the Turntable Hub, and then use the provided belt hoot to help
pull the belt to fit around the slot of motor pulley.
5. Place the turntable platter through the turntable spindle.
6. Place the slip mat on top of the turntable platter.
7. Slide Tonearm Counterweight onto tonearm and twist it lightly onto the rear shaft of
the tonearm.
8. Adjust the counterweight to set proper stylus pressure.
9. Connect AC-DC adaptor to the Power Jack of the unit.
Note: Do not plug the AC power adaptor to power outlet before all the assembly is
completed. Before turning the power on, make sure again all the connection setting are
correct. Always turn off the power when connecting or disconnecting.
Cartridge Down force Adjustment
The Counterweight supplied is suitable for cartridges weighing between 3.0-6.0g.
Gently push and turn the Counterweight onto the rear of the tonearm (with the scale facing
toward the front of the turntable).
Remove the cartridge protection cap.
Lower the tonearm lift and position the cartridge in the space between tonearm rest and
platter.
Carefully rotate the Counterweight until the tonearm balances out. The tonearm should
return to the balanced position if it is moved up or down. This adjustment must be done
carefully.
Once the tonearm is correctly balanced return it to its' rest. Hold the Counterweight
without moving it, and gently rotate the Down force Scale ring until the zero is in line with
black line on the rear of the tonearm. Check whether the arm still balances out.
EN - 16 -
Publicité
