EHEIM 1260 Manuel D'instructions page 8

English
Thank you
for puchasing your new EHEIM pump that provides optimum performance with
maximum safety and reliability.
Safety instructions
All electrical equipment in the water must be disconnected from the mains
during care and maintenance work.
The connecting line of this device can not be replaced. When the line is da-
maged, the device must no longer be used. Never carry the pump by the cable;
do not bend the cable.
The pumps may only be used in garden ponds and their area of protection if in-
stalled according to prevailing regulations. As a means of protection against
overly high shock hazard voltage, the installation must show a leakage current
safety guard with a rated residual current of no more than 30 mA. Please consult
your electrician.
This equipment is not intended for use by persons (including children) with li-
mited physical, sensory or mental abilities or for persons with no experience or
knowledge unless they are supervised by a person responsible for safety or
unless they have received from such a person instructions on how to use the
equipment. Children should be supervised to ensure that they do not play with
the equipment.
Notice: These divices produce magnetic fields which might cause electronic and
mechanical disturbances or damages. This also refers to pacemakers. Please
consult the manuals of medical equipment for the required safety margins.
Attention: Maintenance work presents the risk of crushing th fingers due to high
magnetic forces.
Do not dispose of this product as normal household waste. Take it to your local
refuse collection site.
The product is qualified in accordance with the respective national regulations and
guidelines and meets EC standards.
geprüfte
Sicherheit
Universal Pumps 1260010 and 1262010
Model: see type plate on pump housing
Function
A Motor body
carrying handle
retaining ring
intake side cap.
The pumps 1260010 and 1262010 - suitable for outdoor use - are equipped with
a 10 m cable according to regulations and can be used submerged as well as
outside the water. They are not self-priming; when used outside the water they
must be installed constantly below water level. The pump must not run
dry. Temperature range max. 35°C.
Installation
B The carrying handle should be inserted, from the front, into the upper
groove in the motor body. For pond use, the handle serves to secure
a retaining rope.
- suitable for outdoor use -
mounting plate threaded adaptor, pressure side
impeller assembly
coarse filter intake grille
pump cover with o-ring
threaded adaptor,