Publicité
Les langues disponibles
Les langues disponibles
INOXPAN S.L.
EN - RECOMMENDATIONS TO BEAR IN MIND BEFORE INSTALLATION.
VERY IMPORTANT!
DO NOT REMOVE THE PROTECTIVE PLASTIC FROM THE HOOD UNTIL IT IS COMPLETELY
INSTALLED, IF THIS PLASTIC IS NOT PRESENT IN AREAS THAT COULD HAVE A RISK OF
DAMAGE DURING INSTALLATION, IT IS RECOMMENDED TO APPLY PROTECTIVE
MATERIALS AGAINST IMPACT, SCRATCHES AND CONTACT WITH CORROSIVE AGENTS.
TAKE ESPECIAL CARE DURING THE INSTALLATION IF OTHER WORK IS ALSO IN
PROGRESS, BECAUSE PAINT, SILICON, PLASTER AND OTHER MATERIALS COULD
CONTAIN CORROSIVE CHEMICALS THAT MAY DAMAGE THE PRODUCT, IN THESE CASES
IT IS RECOMMENDED TO ADEQUATELY PROTECT THE HOOD, BY FOR EXAMPLE,
HERMETICALLY COVERING AREAS THAT COULD BE AFFECTED WITH PLASTIC.
THIS WILL AVOID DAMAGE TO THE OUTSIDE OF THE APPLIANCE, SOMETHING THAT
WILL NOT BE COVERED BY THE GUARANTEE.
EN - SAFETY INSTRUCTIONS
- If the hood is to be used at the same time as gas fuelled or other fuelled appliances
(not applicable to appliances exclusively designed to blow air into the room) the room
must be properly ventilated.
- The exhausted air must not be led through a conduit that is used for exhausting fumes
from other appliances using gas or other fuels (not applicable to devices destined
exclusively to discharge the air inside the room).
-The minimum distance between the surface of the cooktop and the lower edge of the
hood must be 65 cm if the the extractor hood is fitted over gas cooker. If the installation
instructions of the gas cooker indicates a greater distance, this must be followed.
- Regulations regarding air evacuation must be respected.
- If the hood does not have a power cable with a plug, or other means for
disconnection from the mains, with a separation of all poles to ensure total
disconnection under category III conditions of overvoltage, means for disconnection of
the fixed installation must be incorporated in accordance with installation regulations.
24
Publicité
