Pattfield Ergo Tools E-WS 230/2350 Instructions De Service page 9

Anleitung E-WS 230-2350_SPK7:_
Swivel handle (Fig. 2)
The handle can be swiveled a maximum 90° to the
left and right. To do so, press the locking plate (1)
and swivel the handle 90° to the left or right.
Important! When the locking plate (1) engages
correctly it makes an audible click.
CARBON BRUSHES
Carbon brushes that are burned, broken or shorter
than 5 mm are to be replaced by original
replacement brushes. Always replace the carbon
brushes in pairs.
GRINDING WHEELS
Never use a grinding or cutting wheel bigger than the
specified diameter.
Before using a grinding or cutting wheel, check its
rated speed. The wheel´s rated speed must be
higher than the idle speed of the right-angle grinder.
Use only grinding and cutting wheels that are
approved for a minimum speed of 6,000 rpm and a
peripheral speed of 80 m/sec.
OPERATING MODES
Rough grinding:
For the best rough grinding results, hold the grinding
wheel at an angle of between 30° and 40° to the
workpiece surface and guide back and forth over the
workpiece in steady movements.
Cutting:
When you use the right-angle grinder for cutting
purposes, avoid tilting it in the cutting plane. The
cutting wheel must have a clean cutting edge.
A diamond cutting wheel is best used to cut hard
stone.
It is prohibited to use the machine on asbestos
materials!
It is prohibited to use the machine on asbestos
materials!
Never use a cutting wheel for rough grinding.
14.12.2007 11:44 Uhr
TECHNICAL DATA
Nominal voltage: 230 V ~ 50 Hz
Power consumption: 2350 W
Idle speed: 6.000 rpm
Max. wheel diameter: 230 mm
Drive spindle thread:
Sound pressure level LPA: 94,8 dB(A)
Sound power level LWA: 107,8 dB(A)
Vibration a 3,9 m/s
hv
Weight
Totally insulated
Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
Cleaning, maintenance and ordering of
spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
Seite 9
GB
M 14
2
5,8 kg
II /
9