Makita EK7301 Manuel D'instructions Et De Sécurité page 30

Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be per-
formed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform the
prescribed maintenance work can lead to accidents!
Users of the Power Cut must not perform any maintenance work not described in this operator's manual. All such work must be
carried out by a MAKITA service center.
General
Before each start
Every day
Every week
Every 3 months
Annually
Storage
Service, spare parts and guarantee
Maintenance and repair
The maintenance and repair of modern cutoff saws and their safety-related components requires qualified technical training and a
workshop equipped with special tools and testing devices.
We therefore recommend that you consult a MAKITA service center for all work not described in this operator's manual.
The MAKITA service centers have all the necessary equipment and skilled and experienced personnel, who can work out cost-effective
solutions and advise you in all matters.
Please contact your nearest service center (list enclosed) or the general trading company or importer (see last page), who will gladly
provide you with the address of your nearest MAKITA service center.
Spare parts
Reliable long-term operation, as well as the safety of your Power Cut, depend among other things on the quality of the spare parts
used. Use only original MAKITA parts, marked
Only original parts are from the same production line as the original unit and therefore ensure the highest possible quality of materi-
als, dimensions, functioning and safety.
Only original spare parts and accessories guarantee the highest quality in material, dimensions and function.
Original spare parts and accessories can be obtained from your local dealer. He will also have the spare part lists to determine the
required spare part numbers, and will be constantly informed about the latest improvements and spare part innovations.
Please bear in mind that if parts other than original MAKITA spare parts are used, this will automatically invalidate the MAKITA
product guarantee.
We will furthermore not accept any liability damages arising from the use of non-MAKITA spare parts.
30
Entire Power Cut
Cutting disc
Clutch
Protection hood
Cutting disc
V-belt
Protective hood
Combination switch,
Safety locking button,
Throttle lever
Tank cap
Air filter
Idle speed
Extreme dust
Starter housing
Starter cable
V-belt
Air filter insert
Spark plug
Muffler
Suction head
Fuel tank
Entire Power Cut
Entire Power Cut
Cutting disc
Fuel tank
Carburetor
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service center immediately
Inspect regularly for damage and wear.
Have inspected at a service center.
Clean, Check position (impact plate)
Inspect for damage and make sure the cutting wheel is
right for the job
Check V-belt tension
Adjust position
Functional check
Functional check
Functional check
Check for tightness and lekages
Clean (if necessary more frequently); pre-filter (foam)
maintenance as described above under Cleaning /
changing the air filter
Check (cutting disc must not turn on idle)
Clean filter insert (paper cartridge)
Clean to ensure proper air cooling
Check for damage
Check V-belt tension, inspect for damage and wear
Clean, replace after 100 operating hours
Check and replace if necessary
Check tightness of mounting, clean or replace
spark arrester screen if necessary
Replace
Clean
Check at an authorized service center
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service center immediately
Remove and clean
Empty and clean
Run empty
Page
7
18
7
15
18
22-23
20
22-23
13
25
15, 21
22-23
24
13 / 28
24
14