Makita EK7301 Manuel D'instructions Et De Sécurité page 11

Maintenance
- Before performing maintenance work switch off the Power
Cut (27) and pull out the plug cap.
Allow the Power Cut to cool off before doing any mainte-
-
nance work (burn hazard)!
- Power Cuts with catalytic converter take longer to cool
down!
- Always check the Power Cut before using it to make sure that
it is in good working order. In particular, make sure that the
cutting disc is properly mounted. Make sure that the cutting
wheel is undamaged and suitable for the job it will be used
for.
- Operate the Power Cut only at a low noise and emission level.
For this ensure the carburetor is adjusted correctly.
- Do not operate the Power Cut with a defective or modified
muffler.
- Clean the Power Cut regularly.
- Check the fuel tank cap regularly for good sealing.
Observe the accident prevention instructions issued by
trade associations and insurance companies. NEVER
make any modifications to the Power Cut! You will only
be putting your own safety at risk!
Perform only the maintenance and repair works described in
the operator's manual. All other work must be carried out by
MAKITA Service.
Use only original MAKITA spares and accessories.
The use of non-MAKITA spares, accessories, or cutting discs
increases the risk of accident. We cannot accept any respon-
sibility for accidents or damage occurring in association with
the use of cutting discs or accessories other than original
MAKITA.
First aid
For the event of a possible accident, please make sure that a
first aid kit is always immediately available close by. Immediately
replace any items used from the first aid box.
When calling for help, give the following information:
- Place of the accident
- What happened
- Number of injured people
- Kind of injuries
- Your name!
NOTE
Individuals with poor circulation who are exposed to excessive
vibration may experience injury to blood vessels or the nervous
system.
Vibration may cause the following symptoms to occur in the fin-
gers, hands or wrists: "Falling asleep" (numbness), tingling, pain,
stabbing sensation, alteration of skin colour or of the skin. If any
of these symptoms occur, see a physician!
Disposal and environmental protection
Be mindful of the environment!
Dispose of worn-out or defective cutting discs in accordance with
your local disposal regulations. To protect unusable cutting discs
from misuse, destroy them before disposal.
When the Power Cut is worn out or damaged beyond repair, have
it disposed of or recycled in an environmentally sound manner. If
necessary, consult your local authorities.
27
SERVICE
28
29
11