INSTALLATION MANUAL
WARNING:
Safety is guaranteed if these instructions are followed and therefore they
must be kept. Installation may require qualified personnel to be involved.
Before proceeding with installation of the device ensure that the
environmental conditions are in compliance with and suitable for the
product characteristics. Before carrying out any operation on the device
remove mains power.
SHELF INSTALLATION (fig. 1,2):
- Secure the light (A) to the shelf (B) using the provided screws (C).
INSTALLATION ON MIRROR (Fig. 3,4,5):
- Remove the support bracket (E) loosening the grub screws (F) (Fig. 3).
- Insert the light (A) onto the mirror (G) ensuring that it is not thicker than
6mm (Fig. 4).
- Secure the light (A) to the mirror (G) using the grub screws (F) (Fig. 4,5).
ELECTRICAL CONNECTION:
- Remove power from the mains.
- Connection of the power supply cable to the 230V mains must be carried
out using the junction box (D) that is provided in the package.
- The power supply cable must not be accessible after installation of the
device.
- If the provided connector terminal is not used, used connection devices
certified in compliance with the EN 60998 standard.
- House this device in an adequately sized box.
WHC VERSION OPERTION (changes colour):
AALTO / LEVEL WHC has a light source with 3 selectable colour
temperatures (3000-4000-6000K). To make this selection proceed as
follows:
Switch AALTO / LEVEL WHC on and then switch off within 10 second and
then switch back on. Each time it is switched on a different colour
temperature will be selected.
To store the selected tone, leave the light on for more than 10-15 seconds.
EN
WARNING
- The LED module of these devices is not replaceable.
- The external flexible cable is not replaceable.
- In case of failure it must be entirely replaced the entire unit.
- Do not use the device if the power cable and/or the connection cables
are defective. Defective cables and/or connectors must be immediately
replaced by qualified personnel authorised by DOMUS Line.
- Never run any cable through sharp corners and edges.
- Never run the cable over hot parts and always protect it against contact
with liquids.
- Install the device in a position that is out of the reach of children.
- If the cable needs to be secured use only insulated clips or plastic cable
ties.
- Ensure that the cable is not crushed between the wall and the mirror.
- Never use extension cables that are not compatible with the original
connection system.
- Before cleaning the device ensure that you have switched it off and wait
until it has cooled.
- Never immerse the device in water.
- To clean the metallic parts of the device use a soft and dry cloth and
never, under any circumstances, use liquid detergents, abrasive products
or similar items that could irreparably scratch and damage the surface.
WARRANTY
- The warranty on the device is valid only if powered by a power supply
provided by DOMUS Line. The warranty's general terms and conditions
for this device are available at www.domusline.com