Publicité
EN Safety
PL Bezpieczeństwo
Measured air pressure at best efficiency point (PBEP) (Pa)
Measured electric power input at best efficiency point (WBEP) (W)
Nominal power of the lighting system (WL) (W)
Average illumination of the lighting system on the cooking surface (Emiddle) (lux)
The measurement and calculation method of the above table was done in accordance with Commission Delegated
Regulation (EU) No 65/2014 & Commission Regulation (EU) No 66/2014.
B. The following shows how to reduce total environmental impact (e.g. energy use) of the cooking process.
1.
Install the cooker hood in a proper place where there is efficient ventilation.
2. Clean the cooker hood regularly so as not to block the airway.
3. Remember to switch off the cooker hood light after cooking.
4. Remember to switch off the cooker hood after cooking.
C. Information for dismantling.
This appliance cannot be dismantled by the user, other than that as shown in the original assembly of the user manual.
At the end of its useful life, the appliance should not be disposed of with household waste. Check with your local
governmental authority, domestic waste disposal services or the retailer where the product was bought for recycling advice.
EN
Troubleshooting
Problem
Excessive vibration.
The light is on, but the fan
does not work.
Both the light and motor
do not work.
Suction performance
reduced.
Works normally but
cooking smells linger.
This appliance respects laws of the suppression of radio interference. As the Manufacturer has a policy of continuous
product improvement, it reserves the right to adapt and carry out any modification considered necessary without prior
warning.
FR Sécurité
RO Siguran ă
Possible cause
The appliance is not installed properly on the
brackets.
The fan blade is damaged.
The fan motor is not fixed tightly.
The fan blade is jammed.
The motor is damaged.
Light bulb blown.
Power connection loose.
Speed may be too low.
Aluminium filters are dirty.
Top vent might be obstructed.
Optional vent kit might be twisted.
The installation may not comply with the
manufacturers instructions.
Carbon filter is not fitted in recirculation
mode or is full of grease.
Solution
Take down the appliance and check it is
properly fixed.
Switch off the appliance. Repair to be carried
out by qualified service personnel only.
Ring the customer helpline at the end of the
Care & maintenance section to arrange an
engineer visit.
Check power supply.
Select a higher speed.
Clean the aluminium filters. (See Care and
maintenance section).
Clear any obstruction.
Ensure that the vent kit is fitted according to
the manufacturer's instructions.
The vent hose should be correct diameter
throughout with no reductions or restriction.
(See installation section).
Fit carbon filter or replace the carbon filter
(See Care and maintenance section).
10
314
80
12
50
Publicité
