Danby Designer DUFM059C1WDD Manuel Du Propriétaire page 6

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Open the door and unscrew the upper hinge
from the right side of the worktop. Remove the
door from the cabinet. Remove the screws in the
left side of the work top. These will be used to
secure the upper hinge later.
2. Remove the hinge hole plug from the top left side
of the door and the bushing from the top right
side of the door and swap their positions.
3. Remove the door stop from the bottom right side
of the door and install it on the bottom left side
of the door.
4. Remove the lower hinge from the bottom right
side of the cabinet and install it on the bottom
left side of the cabinet.
5. Install the door on the lower hinge. Install the
upper hinge on the top left side of the worktop.
Note: When installing the door, ensure that the top
of the door is level with the top of the cabinet. If the
door is not level, the rubber gasket will not make
a good seal with the cabinet which can cause the
appliance to malfunction.
1. Upper Hinge
2. Screws
3. Hinge Hole Cover
4. Bushing
5. Door Stop
6. Lower Hinge
3
5
1
2
4
2
5
6
2
1
2