Publicité
Les langues disponibles
Les langues disponibles
How to charge batteries
from your device and dispose of them
at your local collection point for batteries.
If you don't know the location of
your nearest disposal centre, please
enquire at your local council office.
Liability exclusion:
As manufactures, we at GRAUPNER are not in
a position to ensure that you observe the correct
methods of operation when installing, using and
maintaining this charger. For this reason we are
obliged to deny all liability for loss, damage or
costs which are incurred due to the incompetent
or incorrect use an operation of our products, or
which are connected with such operation in any
way.
Types of rechargeable batteries:
2 V, 6 V and 12 V lead acid batteries with a capa-
city of 2 – 20 Ah. These gastight sealed batteries
have proven their worth for RC operation. They
are mechanical robust and position independent.
The battery label usually allows to draw a conclu-
sion about its capacity:
Example: Graupner lead acid battery 6 V/ 4 Ah:
voltage 6 V, capacity 4 Ah
Charging batteries:
The charger automatically detects the voltage of
the battery, and charges the pack according to
the constant current / constant voltage principle.
6
How to charge batteries
Operation
1. Connect the charger to an easily accessible
mains power socket (120-240V~, 50/60 Hz).
The red LED flashes once to confirm that
the charger is ready for use.
2. Connect the lead battery which is to be
charged to the attachment plugs of the char-
ging cable. Make absolutely sure that the po-
larity of the battery and the polarity of the
charging cable match.
• RED to positive pole (+)
• BLACK to negative pole
The red LED lights up to indicate that
charging is in progress.
3. The LED glows green when the lead-acid
battery is fully charged. Disconnect the bat-
tery from the charge lead, and disconnect
the charger from the mains socket.
Additional information:
If the green control lamp does not switch on
after connecting the battery to the charger and
the charger to the socket, you should immedi-
ately disconnect the charger from the socket in
order to avoid an overstrain or any damage to
the charger.
Possible error causes:
• Incorrect polarity of the battery connector,
the battery charge lead or the battery, or
short-circuit at the output.
The red LED flashes to indicate any of these
faults.
• Battery defective, intermittent contact, inter-
ruption, etc.
• Mains socket without current or defective.
• Charger defective. In this case, please con-
tact the GRAUPNER service department.
Publicité
